Waste oil recycling to diesel plant
3-D picture of waste oil recycling to diesel plant
For our waste oil recycling to diesel plant, the applicable raw material can be any kinds of waste oil ,such as tire oil ,plastic oil ,waste engine oil ,black oil ,heavery oil ,motor oil,etc.
Raw material of waste oil recycling to diesel plant
Diesel oil application
2. Heating system works to heat waste oil over 170℃
3. Distillation oil gas produced and cooling down to pure distillation oil by condensers
4. After distillation, the distillation oil is pumped into odor-removal tank where catalysts are used to remove the smell
5. Then oil go into color-removal tank for de-coloring with the special catalysts
6. Finally, you can get about 85% pure diesel oil.
By using the heat transfer heating system, our client can save much fuel to heat the whole reactor, and the heating speed is faster and the temperature can keep the reactor hot for longer time,so the whole process is faster with less fuel
2: The heating circulation system is more environmental
All the heat transfer system is a circulating system, the heat transfer oil is recycling inside the reactor. So in total, you can fire less fuel, which not only save your cost on fuel also it is more environmental-friendly. All the system is sealed,and in the terms of smoke and smell, our new design Used oil refining plant works better.
3:The vertical reactor
From our design,It is very easy to clean the slag . It will be down through the bottom of the vertical reactors. So the operation is easier
4: Continuously working
When operating the machine,first you pump oil inside the reactor to heat. After finishing heating,it will become oil gas and goes to cooling system,then go to another tank.So,the first reactor is empty,no need to stop,you could pump another tank of oil again into the first tank ,continuously working.
|Technical parameter of waste oil recycling to diesel plant|
|Model||DY-5t, DY-10t, DY-20t, DY-50t…|
|Raw material||motor oil, waste tire oil, plastic oil,engine oil|
|Structure form||Vertical (easy cleaning and maintenance)|
|Heating method||Indirect heating to prolong the machine service life|
|Operating pressure||Constant pressure|
|Heating material||Coal, charcoal, fuel gas, fuel oil|
|Average out-put oil rate||95%|
|Material of reactor||4 reactor with different material|
|Thickness of reactor||18mm|
|Mode of cooling||Recycled water cooling|
|Power in total||20 Kw|
|Service life||average 7 years|
Leave a message